Baja WD250U Service Manual page 46

2. Adjust
1
• Free clearance of left lever.
• Free clearance of rear brake pedal.
Adjusting procedure:
2 CAUTION:
Before adjusting, depress the rear brake pedal
2-3 times.
• Loosen the locking nut (1) completely, and
screw in the cable adjusting screw (2)
completely.
• Loosen adjusting nut (3) of the rear brake
cable and adjusting nut (4) of rear brake.
• Tighten the adjusting nut (4) of rear brake
6
3
pedal until correct clearance is met: Free
clearance (rear brake pedal):20-30mm.
5
4
• Rotate adjusting nut (3) of rear brake cable
until correct clearance is met :
0-1mm
5 Rear brake arm assy.
6 Pin
• Screw out the adjusting screw (2) of rear
brake cable untl gaining correct free clearance
(b) :Free clearance (b) (left lever):5-7mm
a
• Screw up the locking nut (1)
• Check the free clearance of left lever and
rear brake pedal.
If is does not meet the standard value, repeat
above procedures to adjust.
b
WARNING:
1
After adjusting, raise the rear wheels from the
ground and rotate them to confirm no brake
force to block the rotation.
2
Otherwise repeat above adjustment.
46