Baja WD250U Service Manual page 193

3 2
4
2
2
1
3
1
4. Main, vice clutch
1) Installment:
• Clutch gear assy (secondary)
• Spline washer (2)
2) Installment:
• Friction plate (1)
• Clutch plate (2) (Install the clutch hub (3))
CAUTION:
Install the clutch plate and friction plate to the
clutch hub alternately, from friction plate to
friction plate.
3) Installment:
• Clutch hub
(Install to pressure plate)
CAUTION:
The arrow mark (3) of clutch hub should align
with the arrow mark (4) on the pressure plate.
4) Installment:
• Clutch hub, pressure plate, clutch plate, and
friction plate assy (1) (to main shaft (2))
• Locking washer (3)
• Nut (4)
CAUTION:
Be sure to use new locking
• Be sure to install the locking washer inside
the indent of clutch hub.
5) Tighten up:
• Nut (4) (Clutch hub)
CAUTION:
Fasten the clutch hub, then tighten up the
192