(I) Removal Steps - Baja WD250U Service Manual

(I) Removal steps

1. Rest the motorcycle on a flat ground. Press
the brake clip (1) .
2. Loosen the connecting nuts of front and rear
wheels.
3. Stop up the front wheel with wood, then put
a proper supporting article under the frame
so as to lift the rear wheel and make the rear
wheel leave the earth.
WARNING:
In order to avoid the parts falling, (which will
cause danger), during the removal process, rest
the vehicle firmly.
4. Removal (the Ser. No. is corresponding to
the Ser. No. on the drawing)
(1) Connecting nut of front and rear wheels
(2) Left rear wheel
(3) Split pin
(4) Rear wheel axle nut
(5) Washer
(6) Rear wheel connecting plate
5. Removal (the Ser. No. is corresponding to
the Ser. No. on the drawing)
(1) Connecting nut if front and rear wheels
(2) Right rear wheel
(3) Split pin
(4) Rear wheel axle nut
(5) Washer
6. Loosen the rear brake clip
7. Removal:
Brake shoe assy (1)
83