Baja WD250U Service Manual page 87

8. Inspection (The Ser. No. as shown on the
drawing)
1 Inner surface of rear brake hub
If there is some engine oil or scraped markings,
remove it and treat it. The method of treat is as
follows:
Removal of engine oil: Clean with cloth dipped
in volatile dilute or volatile solvent.
Removal of scraped marking: wipe slightly and
with even force the scraped marking to remove
it.
(2) Gear groove of rear brake hub
If worn or damaged, replace it.
9. Inspection
(1) If there are any cracks, bends, or damage
on the brake cover, replace it.
(2) If the dust-proof seal is worn or damaged,
replace it.
10. Inspection
(1) If there is worn, scraped marking, or dam-
age on the cam shaft of rear brake, replace it.
(2) If the air pipe of rear brake is clogged,
remove this pipe and clean the dirt, if damaged,
replace it.
11. Clean the air hole on the rear brake cover
with compressed air.
12. Inspection of rear wheel axle (1)
a: If the rear wheel axle is heavily scraped or
broken, replace it.
b: If the thread or gear groove on the rear wheel
axle is worn or damaged, replace it.
86