Section 1 Disassembly Of Engine - Baja WD250U Service Manual

8. Rear diving unit and rocker (rear wheel fork
and shock absorber)
1) Remove
• Remove the air (1) (gear case of last grade
and rear brake hub) from the clip on the frame
• Fix the front wheel and raise up the rear wheel
(place the supporter on the frame)
2) Remove
• Bolt (1) (Upper end of the rear shock
absorber)
3) Remove
• Hoop (1) (rubber hood)
• Dustproof cap of rear arm shaft (2)
• Rear arm nut (3) (right)
• Connecting screw column of rear arm (4)
(right)
• Connecting bolt of rear arm (5) (left)
4) Remove
• Rear wheel driving unit/rocker assy
CAUTION:
• When disassembling the rocker assy, support
the shock absorber to avoid dropping down.
• When removing the rocker from the rubber
hood, the driving shaft may drop down. Pay
attention not to lose components.
9. Disassembly of engine
1) Remove
• Bolt (1) (top supporting of engine)
• Bolt (2) (bottom supporting of engine)
• Bolt (3) (rear upper supporting of engine)
• Bolt (4) (rear lower supporting of engine)
2) Remove the engine unit from right side
144