Baja WD250U Service Manual page 39

5
1
2
6
2
3
2. Installation
2
Reverse procedure for "Disassembly". Pay at-
tention to the following points:
1- Install:
Rear fender (1)
Bolt (2) (rear fender and frame). The
1
torsion in 7N·m.
Bolt (3) and rubber hood of protecting plate
(rear fender and frame). The torsion is 7N·m.
3
2- Install:
a.Battery (1)
3
b.Battery clamp plate (2)
4
3- Install:
a. Cut-ff relay (3)
b.Starting relay (4)
c.Connect the positive wire (6) to battery
d.Connect the negative wire (5) to battery
4- Install the cushion (1)
1
CAUTION:
Insert the support lug (2) of cushion into the
plug seat (3) on the frame, then press down on
the seat.
1
5- Install rear luggage carrier (1)
Torque requirement for fasteners:
Bolt (2) fastening torque: 3N·m
2
Bolt (3) fastening torque: 9N·m
CAUTION:
Remember to install the bushing on the con-
necting point of luggage carrier and frame.
3
39