Baja WD250U Service Manual page 127

Operation
4. Power off relay
• Remove relay from cable
• Connect portable multitester (Ωx1) and bat-
tery (12V) to end of wire on relay
Battery end (+) - red/white wire end (1)
Battery end (-) - green/yellow wire end (2)
Mutlitester pen (+) - red/white wire end (1)
Multitester pen (-) - blue/white wire end (3)
• Inspect if the power off relay is on
The circuit is on
5. Starting relay
• Remove the connector of the starting relay
from cable.
• Connect the multimeter (Ωx1) and battery
(12V) to end of wire on relay.
Battery end (+) - blue/white wire end (1)
Battery end (-) - black wire direction (2)
Mutlitester pen (+) - red wire end (3)
Multitester pen (-) - black wire end (4)
Inspect if the starting relay is on
The circuit is on
No rotation
Repair or replace starting motor
The circuit is NOT on
Replace power off relay
The circuit is NOT on
Replace the starting off relay
126