Section 6 Wiring Diagram Of Atv; (I) Technical Explanation And Requirement, Details Of Relative Component - Baja WD250U Service Manual

Section 6 Wiring diagram
(I) Technical explanation and requirements, details of relative component.
1. Technical explanation
[A] Main switch wire, indicator wire, mileage
meter wire (mounting digital mileage meter)
must be put through the guide grip of holding
seat of steering bar (see figure 1).
[B] Rear brake vent-pipe, carburetor vent-pipe
and vent-pipe of rear driving gearbox must be
inserted into the hole of supporting pad of vent-
pipe (see figure 1 also see view D).
[C] Neutral and reverse switch wire, mileage
meter wire (moutning with digital mileage me-
ter) should be fixed with bands (see figure 1).
[D] After putting overflow pipe of carburetor
through two rear fixing part of engine (on the
frame) put it ino the proper position between
engine and rear arm. NOTE: overflow pipe
must not be blocked (see figure 1).
[S] After putting rear brake cable, throttle
cable, wire of starting motor and mileage meter
(mounting with digital mileage meter) through
wire hook 2, bend wire hook 2 according to the
method of view A.
[P] Starting motor wire and mileage meter wire
(mount with digital mileage meter) must be put
through the hole of the plastic grip in the fuel
tank support of frame (see figure B-B)
[R] Rear brake cable, rear brake vent-pipe
and mileage wire (mount with digital mileage
meter) must be first put through wire hook 2,
then connect with respective matching unit (see
figure B-B).
[Q] Wire of reverse switch, neutral switch and
mileage meter (mount wih digital mileage me-
ter) must be fixed with bands (see figure B-B).
[T] When assembling the wire for ser. No.14
and No.15 do not put through the guide clip of
holding seat of steering bar See figure E-E).
[W] After putting the fuel tank vent tube though
the hole of main switch, lead it to the lower
right side of steering bar, then put it through the
wire hook on the frame. NOTE: Hose must be
unlocked (see figure E-E).
[V] The leading wire on the switch units of
steering bar, must be bound with the band (see
figure G-G).
[E] After the vent-tube of the front brake is put
through the plastic clip hole on the frame the
excess should be put in the proper position of
frame (see figure 2).
[G] After the vent-pipe of battery is checked and
free of twists, insert it in the preset hole of rear
fender (If free of maintenance battery is used,
then this item of requirement isn't needed)
[H] Wire of rear brake cable, rear brake vent-
pipe and mileage meter (mounted with a digital
mileage meter) should be put through the cable
frame welded on the frame. (see figure3).
[F] Wire of starting motor must be first put
through the plastic clip on the frame, then con-
nected with the matching units (see figure 3).
[L] Vent-tube of battery should be put through
the plastic clip fixed on the frame. (see figure3).
[K] The throttle cable wire, rear brake cable and
mileage meter (mounted using a digital mile-
age meter) should be pout through the cable
guide frame welded to the frame. (throttle cable
should be mounted on the inner side)
(see figure 4).
[J] Insert the starting relay into the rear fender
(see figure 4).
[M] After putting the vent-tube of battery
through the plastic clip mounted on the rear
fender, insert into the hole on rear fender (com-
bine with G) (see figure [G]) (see figure 4).
21