Baja WD250U Service Manual page 11

7. Check of electric parts
7.1 Make sure there is no rust, dirt or moisture at the
connection, if there is blow it dry or clean.
7.2 The electrolyte inside the battery is corrosive,
take extra precautions as to not get this on your
body.
7.3 When repairing wires on electrical parts, remove
the wire on the terminal of negative pole of battery
(see figure 7.1). When tightening or loosening bolt
on terminal of battery, do not let the wrench contact
the engine or other metal parts of the vehicle body to
avoid electric shock.
7.4 When connecting the wire to battery, first con-
nect the positive pole then connect the negative pole.
After wires are connected, apply clean grease on the
terminal to increase resistence of rust.
7.5 Check the terminal of connector
A. Grip the two terminals of connector together,
check with the multimeter (see figures 7.3 and 7.4)
11