Baja WD250U Service Manual page 85

8. Removal: (the Ser. No. as shown on the
drawing)
(1) Adjusting nut, pin and spring of rear
brake arm and rear brake tension rod assy.
9. Removal:
(2) Rear brake cable
(3) Rear brake tension rod assy
(4) Air pipe of rear brake
10. Removal:
(1) Rear brake bearing block
(2) Rear brake hub
11. Removal
(1) Tension spring
(2) Rear brake arm
(3) Brake indicating plate
(4) Rear brake cam shaft
12. Removal:
(1) O-ring 30x1.8G
(2) Plain pad of rear brake cover
13. Removal:
(1) Rear wheel axle: Beat the right end of
the rear wheel axle, slightly pull the rear wheel
axle from left end.
CAUTION:
Take out the rear wheel axle from the end of
rear wheel axle bushing and gear box with soft
hammer.
WARNING:
While taking out the rear wheel axle, in order
to protect the thread
and gear groove from damage, do not beat the
rear wheel axle directly with hammer.
84