Baja WD250U Service Manual page 48

(VI) Replacing engine oil of rear driving gear case.
1. Place the vehicle on level ground.
2. Place an oil catcher under the rear driving gear
case.
3. Remove:
• Lower cover of gear case
• Oil fillin screw plug
• Oil drain screw plug (1)
Drain out the engine oil of the rear driving gear
case.
4. Check:
• Sealing washer (oil fill screw plug position)
1
• Sealing washer (oil drain screw plug position)
If damaged, replace it.
5. Install:
Oil drain screw plug (rear driving gear case)
Torsion of oil drain screw plug: 23N·m
6. Oil fill screw plug
CAUTION:
Avoid any forgein matter from entering the driving
gear case.
Recommended oil:
SAE80API "GL-4" engine oil of hypoid gear
If needed, you may use SAE80W90 engine oil of
hypoid gear
Period replacement:
0.12L
Total capacity:
0.27L
7. Install:
• Oil fill srew plug (rear drain gear case)
CAUTION:
After refilling, check for leaks.
Torsion of oil fill screw plug: 23N·m
48