Section 6 Troubleshooting Electric Starting System - Baja WD250U Service Manual

Section 6 Troubleshooting electric starting system
If starting motor does not work
• Check
1. Safety
2. Battery
3. Starting motor
4. Cut-off relay
5. Starting relay
• Remove the following parts before trouble-
shooting
1) Cushion
2) Front frame
3) Front fender
1. Safety
Refer to "Check of switch"
PASS
2. Battery
• Check the condition of the battery
Refer to "Check battery" chapter 3
Voltage of open circuit
At 20˚C (68˚F), 12.8V or much more
PASS
3. Starting motor
• Connect the positive terminal (1) of the
battery to cable (2) of starting motor by
wire (3)
• Inspect the running condition of starting
motor
6. Main switch
7. Neutral switch
8. Rear brake switch
9. Starting switch
10. Circuit connection
(entire startinf system)
Pocket multimeter
No electricty
Replace the safety
•Clean the battery terminal
• Recharge or replace the battery
WARNING:
• Jumper wire must have the same or bigger
loading capability than battery wire, other-
wise it will burn
• This kind of testing is similar to making
electric spark, therefore, no inflammable air
or liquid should be kept near.
125
FAIL