Section 3 Identification Code, Label Of Model And Engine No; Section 4 Points For Attention In Maintenance - Baja WD250U Service Manual

Section 3 Identification code, label
of model and engine No.

Section 4 Points for attention in maintenance

1. Preparation when disassembling
1.1 First clean the dirt and mud from the vehicle before removing or disassebmling.
1.2 Use proper cleaning device and tools.
1.3 Keep all the components away from fire. Pay attention to hot surfaces such as the engine,
exhuast etc.
1.4 When disassembling the ATV, keep alike parts such as gear pairs, cylinder, piston, etc.
together. When assembling or replacing these components they should be kept in pairs.
1.5 When disassembling the engine, clean all components and place in a tray in the order of dis-
assembly, not only increasing the assembling speed, but also ensuring the correct assembly.
2. Replace the components
When replacing components use only the products, lubricants and grease recommened by manu-
facturer.
3. Oil seal, shim, O-ring, clip, split pin, elastic washer
3.1 When disassembling to maintain the engine, to ensure that the reassembled engine has good
sealing and connected parts are fixed and reliable, the oil seal, shim, o-ring, clip, split pin and
elastic washer should be replaced, be sure to keep lip of oil seal, surface of shim and o-ring in a
clean condition.
3.2 When reassembling, apply lubricant to all the alike components and bearings,
apply grease for oil seal.
Identification code
Engraved in the left or right side of the front
supporting main tube of engine of frame
Engine No.
This is engraved on the top middle part of the
right crankcase of engine.
9