(Vii) Rubber Sleeve Inspection Of Rear Wheel Fork; (Viii) Inspection Of Steering System - Baja WD250U Service Manual

(VII) Rubber sleeve inspection of rear wheel fork

check
• Rubber sleeve (1)
If damaged or worn, replace it.
Refer to chapter 3 section 6 "rear shock absorber
and rear wheel fork".

(VIII) Inspection of steering system

1. Place the vehicle on level ground
2. Check:
• Clamp seat of steering column and
1
bearing on the lower end of the steering column,
upper & lower and front & rear moving section
steering bar.
If the clearance is too large, replace the bearing.
Refer to Chapter 3 section 4 "Steering system".
3. Check:
• Ball pin unit of steering tension rod.
Rotate the steering bar leftward and/or rightward,
then rotate from left to right. If the ball pin unit (1)
of steering tension rod has too much
vertical clearance, replace it.
1
Refer to Chapter 3 section 4 "Steering system".
4. Lift the front end of vehicle to make the front
wheel not bear any load.
5. Check:
• Left/right front seat assy on front brake position,
and/or bearing 6005-2Z/bearing 6203. When
moving the wheel back and forth horizontally, if
the clearance is too large, replace the following
components:
1) Bearing 6005-2Z/bearing 6203
2) Left/right front seat assy (1)
3) Split pin (2)
4) Front fork ball connection (3)
5) Bushing assy (4)
Refer to Chapter 3 section 4 "Steering system.
49