Baja WD250U Service Manual page 114

3. Fix the rear arm joint bolt (1) (left), rear
arm joint bolt (2) (right) and bush (3) .
Fixing steps:
a: Fix the left rear arm joint bolt (1) by stan-
dard torque.
Attached: Bolt torque value: 130Nm
b: Fix the right rear arm joint bolt (2) until it
makes contact with its bush (3) .
Attached: Bolt torque value: 6Nm
c: Fix right rear arm nut (4) by standard torque.
Attached: Rear arm nut torque: 130Nm
4. Check rear wheel fork free clearance.
Refer to step 8 in "disassembly"
5. Lubricate the upper and lower end surface of
rear shock absorber (see figure)
Use Lithium base grease as lubrication oil
6. Mount rear shock absorber
Upper nut torque of rear shock absorber: 50Nm
7. Mount slip pin
113