2
1
3. Installation:
Follow the opposite steps of "Removal".
(1) Mount:
a. Valve cap (1) (side of outlet door)
b. Valve cap (2) ( side of inlet door)
CAUTION:
(i) Project of valve cap (1) (2) should be up
(3)
(ii) Check if the o-ring (4) is damaged, if so re-
place immediately.
Torque of valve cap: 10N·m
(2) Mount:
a. Oil tank (see oil tank installation in this section)
b. Upper cover of oil tank
c. Seat (see installation of seat in section 2)
(VIII) Adjustment of timing chain tension
The engine has an automatic adjusting tensioner on
the chain, so manual adjustment is not neccessary.
65