Baja WD250U Service Manual page 112

2. Check if the rear wheel fork assy is cracked,
bent, and damaged. If any, replace it.
Check if the rear wheel bush is cracked, bent,
and damaged. If there is one of these problems,
replace it.
3. Check the gear case lower cap. If there are
any cracks, bends, or damage, replace this part.
4. Check the rear arm joint bolt (1) , rear arm
joint bolt (2) , and bush (3) . If one of these
parts are worn or damaged, replace it.
5. Check the bearing 30203 (1) of rear wheel
fork assy, if there is free clearance during the
bearing match with the rear wheel fork, or un-
even swirl, replace the bearing. Check the oil
sealing (2) . If it is worn or damaged, replace
it.
Replacing steps of bearing 30203 and oil seal-
ing.
a. Clean the bearing round
b. Take off the oil sealing (1) with flat screw-
driver.
CAUTION:
Put a wooden block (2) at the outer side in
order to protect the outer side.
111