Baja WD250U Service Manual page 106

5. Mount the split pin (3)
CAUTION:
Don't loosen the nut after marking the standard
torque. If the recess on the nut does not corre-
spond with split pin hole on the bolt, correct it
by tightening the nut.
WARNING:
Must use new split pin.
6. Mount:
Front shock absorber (4) , front shock absorb-
er nut (5) , bolt (6) under the front shock
absorber.
CAUTION:
Before fixing the front shock absorber nut (5)
you must ensure that the side plane (8) of
universal joint (7) is limited by frame limited
block.
The head of bolt should be forward. The cor-
rection of bolt mounting direction (6) under
the front shock absorber should be guaranteed.
7. Tighten the nut (5) , bolt of front shock
absorber (6)
Attached: Nut torque of front shock absorber:
5Nm
Bolt torque: 78Nm
8. Mount circlip (7)
9. Mount steering lever ball pin assembly (1) ,
nut (2) and split pin (3)
Attached: Nut torque: 25Nm
105