Baja WD250U Service Manual page 223

6. Mount:
4
• Torsion spring (starting ratchet pawl) (1)
• Starting ratchet pawl (2)
• Hog Ring (3)
• Compress spring (4)
• Guide plate (5)
• Screw pin (6)
CAUTION:
When mounting torsion spring (starting ratchet
pawl), make the end (7) of torsion spring
align to groove A on the drive disc.
5
2 1
3 6
7. Turn the drive disc 3 circles by clockwise,
and pre-tighten the coil spring.
8. Mount:
• Starting lever (1)
1
• Cover (2)
CAUTION:
Make the rope across the hole of left side, and
knit it so that the rope is not pulled into left
side cover.
• After knitting (4), and untie.
4 2
221