Section 13 Inspection Of Signal System - Baja WD250U Service Manual

Section 13 Inspection of Signal System
(I) If the neutral indicator lamp is out
1. Bulb and socket
•Check if the bulb and socket circuit B are
correct.
PASS
2. Neutral switch
• Refer to "Inspection of switch"
PASS
3. Voltage
• Connect pocket tester (DC 20V) to the tail-
lamp terminal
Pocket tester (+) - brown terminal (2)
Pcoket tester (-) - sky blue terminal (1)
• Adjust main switch to "ON" position
• Check voltage (12V)
Meet specification
No failure on this circuit
No electricity
Replace bulb and socket
No electricity
Replace neutral switch
Out of specification
If there is failure on the circuit from the main
switch to the bulb socket, repair it.
139