Baja WD250U Service Manual page 133

• Start engine and accelerate to 2000r/m
Charging Voltage: 14-15V at 2000r/m
Use fully charged battery
Out of specification
4. Resistence value for stator coil
• Remove the lighting coil of AC magneto
• Connect pocket multimeter to stator coil
(Ωx1)
Pocket multimeter (+) - white terminal 1
Pocket multimeter (-) - white terminal 2
Pocket multimeter (+) - white terminal 3
Pocket multimeter (-) - white terminal 4
Measure the resistence value of stator coil
At 20˚C (68˚F), 1.10-1.50Ω
Specification met
5. Coupling of circuit
• Circuit the whole coupling of charging wire.
Refer to "Electric diagram"
Correct
Replace rectified adjuster
Specification met
No failure on charging circuit
Out of specification
Replace parts of stator coil
Poor connection
Connect the charging system correctly
132