Baja WD250U Service Manual page 98

2. Lubricate the steering vertical column hold-
er (1) and seal ring (2) during installation
of the steering vertical column welding.
3. Installment
Install the seal ring (1) to the steering verti-
cal column welding, then install bushing (2).
Finally, install the steering vertical column
holder (3).
CAUTION:
Never damage the seal ring when installing.
4. Installment
When installing the steering vertical column
holder and steering vertical column welding
take them as a unit.
WARNING:
In order to ensure that the correct circuit of
brake cable and wire, never damage and wind
the cables and wires.
5. Installment of left and right tension rod (2)
CAUTION:
Make sure that the ball pin (1) at the side of
scraped marking connects with the front seat
assy of front brake.
1
6. Tighten up the nut (1) of ball
97