Baja WD250U Service Manual page 124

8. Resistence value of charge coil
• Remove the corresponding connector of
charge coil from cable.
• Connect the multitester (Ωx100) to wire end
of charge oil
Multitester pen (+) - yellow/green wire end(1)
Multiteser pen (-) - red wire end (2)
Inspect if the resistence value is not at the
specification
Coil resistence value
At 20˚C (68˚F), 450~550Ω
PASS
9. Wire connection
• Check the connection of entire igntion sys-
tem
Refer to "Electric diagram"
PASS
Replace CDI assembly
Replace charge coil
Poor contact
Connect the ignitionsystem correcly
123
FAIL