(Ii) Inspection Stepes - Baja WD250U Service Manual

(II) Inspection steps:
1. Inspection
When inspecting the real wheel, refer to "Tire
Inspection", "Rim Inspection" Section of chap-
ter 2.
2. Measurement:
a: radial run-out of rim
b: Tire surface
Refer to "Front wheel and Front Brake Inspec-
tion" Section of this chapter
3. Inspection
(1) Rear wheel connection plate (1) , if
cracks or damage is found, replace it.
(2) Involute splint on rear wheel connecting
plate (2) . If worn or damaged, replace it.
4. Inspection:
Friction plate of rear brake
5. Measurement
Thickness of brake friction plate
See the "Front wheel and Front brake inspec-
tion" section of this chapter.
Attached: The thickness of brake friction plate
is: 4.0mm (0.16in)
<Wear limit>: 2.0mm (0.08in)
6. Inspection
Tension spring of brake shoe
See the "Front wheel and Front brake Inspec-
tion" section of this chapter
7. Measurement
Internal diameter of rear brake hub (a)
If out of specification, replace the hub
Attached: Internal diameter of rear brake hub:
160mm
<Wear limit>: 161mm
85