Baja WD250U Service Manual page 10

4. Clip
4.1 Before assembling, check all the clips carefully.
Replace with a new one after removing from piston
pin. When mounting clip ring (1), make the sharp
end face (2) on the opposite position of
impacted face (3) of clip. (see figure at left)
5. Locking washer/shim and location pin
5.1 When reassembling, replace all locking washer/
shim and location pin (a) . After bolt or nut is in the
lock position, bend and fix both ends of locking shim
along head of bolt or direction of nut.
6. Bearing and oil seal
6.1 When assembling bearing and oil seal, put the
mark (specification of manufacturer) outside. When
assembling oil seal, apply a thin layer of lithium-
based grease on the lip of oil seal.
CAUTION:
Do not dry inside of bearing by blowing out with
compressed air, this will cause damage to the surface
of the bearing.
10