Baja WD250U Service Manual page 201

7) Mount:
• Output shaft
• Connecting claw
• Front splice
• Washer
• Nut
8) Fasten
• Nut (5)
CAUTION:
• Fix the front splice with universal joint
holder and connect the locking nut.
• Apply the thread fastening agent on the nut
when mounting it.
9) Mount:
• Rear joint and driving fork.
Mounting steps
1
• Mount the relative driving fork into the splice
• Coat grease on the needle bearing
• Press every needle bearing (1) into the front
splice with proper tube to ensure that the
driving fork is inserted into the needle bearing
hole
• Fix the hog ring into every bearing groove
CAUTION:
• Check every needle because the needle may
drop out from bearing cone to lose. If it is like
this the universal joint can't be turned flexibly.
• Insert the needle bearing into universal joint
entirely to ensure the hog ring can be mounted.
200