(Iii) Mounting Steps - Baja WD250U Service Manual

Take off bearing (3) with usually bearing tool.
The reverse step of "bearing and oil sealing
replacing step" is the mounting step of new
bearing and new oil sealing.
CAUTION:
Use a pressure tooling (4) which is matched
with outer diameter of bearing race (7) and
oil sealing.
WARNING:
Don't strike the bearing inner race (5) and
roller. The pressure tooling (4) is only in
contact with outer race (7) .

(III) Mounting steps:

The reverse step of "disassembly" is the
mounting step, but the following points must
be paid attention to during the installation:
1. Lubricate the bearing (10, oil sealing (2)),
bush (3) , and rear arm joint bolt (4) .
Lubrication oil is Lithium base grease.
2. Mount the real wheel fork assy, rear wheel
fork bushing and rear arm joint bolt.
112