Baja WD250U Service Manual page 12

B. If there is slack in the joint, bend the plug pin
upward, then connect with connector plug (see figure
7.5)
7.6 Before mounting the new fuse, check if the load
of fuse on the components are correct, especially the
portion being broken regularly, then mount the fuse
having proper current value.
7.7 There are two kinds of wire connectors, a single-
head connector, another a multi-head connector.
Before connecting single-head connector, make sure
there are no defects on the housing of the joints.
When inserting the joint, after defects are fixed, put
plastic coating on.
In general, multi-head connectors are plastic and
designed to lock. When disassembling the connector,
first open lock; when connecting again make sure the
joints are in good condition and there are no bends
or twists. After connecting, align the lock device and
lock.
8. Use torque spanner to tighten screw and nut, and
as per specified torque. It should be tightened in
steps from big to small, from inside to outside and
along the direction of a diagonal line that intersects
(see figure 8.1).
12