Related Manuals for Baja X250
Summary of Contents for Baja X250
- Page 1 X250 Dirt Bike Set Up Instructions Removal from crate 1. Remove cardboard carton. 2. Remove metal frame and parts included.
-
Page 2: Parts And Hardware
Parts and Hardware Number plate Side fender Side fender Tools Gas cap and vent tube Rear foot brake pedal Battery acid... - Page 3 Rear foot brake pedal Bolts 3. Attach rear foot brake pedal to lever. Bolt size 6mm QTY 2. Torque bolts 6-8ft lbs (8-11Nm) Handlebar Spacer 4. Attach handlebar to forks using allen head screw. Be sure to place spacer between handlebar clamp and fork. Screw size 8mm QTY 4.
-
Page 4: Ignition Switch
Ignition Switch 5. Attach ignition switch assembly to handlebars and attach electrical plug to wire harness. Screw size 6mm QTY 2 Number plate 6. Attach number plate Bolt size 6mm QTY 2... -
Page 5: Side Covers
Side covers 7. Attach left and right side fenders. Bolt size 6mm QTY 6 (3per side) Gas cap 8. Twist gas cap onto gas tank. - Page 6 Battery 9. Remove bolt holding rear side fender and seat to frame. Remove battery WARNING The following procedure is very dangerous and should be performed with utmost care and attention. Wear protective eye wear, rubber gloves, and have water available should electrolyte come in contact with skin or eyes.
- Page 7 Battery Preparing the battery: · Place battery on level surface. Remove sealing tape from top. (see figure 1) · Take the electrolyte container out of the plastic bag. · Place electrolyte container upside down with the sealed silver mouths of the electrolyte bottles in line with the six filler holes of the battery.
- Page 8 Battery How to Initially Charge the battery: 1. Connect the red positive (+) cable to the red positive (+) pole of the battery. (see figure 5) 2. Connect the black negative (-) cable to the black negative (-) pole of the battery. (see figure 6) Note: The red positive (+) cable has a larger diameter than the black negative y cable.
- Page 9 Gas and Oil 10. Fill gas tank as specified in owners manual. !!WARNING!! This engine may be shipped with oil in it. This oil 11. Refer to owners manual for should be drained and replaced with new engine proper starting instructions. oil as described in the owners manual.