Baja WD250U Service Manual page 154

2
7
1
4
5
3
1
3
34. Remove
• Locking washer (1)
• Balance shaft gear (2)
• Flat key (3)
35. Remove
•All the closing case screw.
CAUTION:
Loosen and remove every screw ¼ circle with
phillipshead screwdriver.
36. Remove
• Left crankcase (1)
• Location pin (2)
CAUTION:
• Disassemble the left crankcase with crankcase
separator.
• Tighten up the screw of separator, and must
keep the separator body parallel with crankcase
face. If necessary, screw the screw in reverse
direction to adjust the separator body level.
• When applying force to case body
separator, knock the front supporter of engine,
shift shaft and balance shaft alternately and
continually.
37. Remove
• Long fork shaft (1)
• Short fork shaft (2)
• Shift cam shaft (3)
• Fork 3 (4)
• Fork 2 (5)
• Fork 1 (6)
CAUTION:
Pay attention to position of every part,
6
especially the position and direction of every
2
fork.
153