Baja WD250U Service Manual page 69

2
b. Completely remove the dipstick (1) and
clean it before inserting it back into the oil hole.
c. Remove the dipstick (1) . Make certain that
the oil level is between the max value (2) and
3
min value (3) .
d. Put some engine oil in to get te proper oil
quantity if it was too small. See diagram to the
left for recommended oil quantity.
CAUTION:
1
Recommended oil type:
U·S·A Petrol Association offers:
"SE" and "SF" type oil such as:
"SF-SE-CC", "SF-SE-SD", etc.
(XII) Inspection of oil flow and replacement of
engine oil.
CAUTION:
The clutch can be lubricated with engine oil, but
do not use any chemical additive in machine oil
because it can cause the clutch to breakdown.
Foreign matter should not be permitted in the
crankcase.
1. Put vehicle on flat ground
2. Pre-heat the engine and stop after several min-
utes.
3. Place a container under the engine.
4. Remove oil dipstick and draining plug (1) to
drain engine oil.
WARNING:
It is easy to lose the draining plug, compressor
spring (3) , rough filter (4) , and O-ring (2)
when they have been removed. Pay attention to
these parts.
5. Remove fire-filter cap (5) , fine filter (6) ,
and O-ring (7) .
68