(V) Installation Steps Of Steering Bar - Baja WD250U Service Manual

(V) Installation steps of steering bar

1. Install the lower holding seat (1) , steering
tube (2) and upper holding seat (3) .
WARNING:
When tightening the bolt of holding seat, make
sure clearance (b) is clear.
Attached: bolt torque: 20Nm
2. Install the throttle grip unit
CAUTION:
The projection (1) of throttle grip must cor-
respond with the sunken part (2) on the right
lever seat when installed.
WARNING:
Correct installation of cable and wire is very
necessary to ensure the safe operation of ve-
hicle.
Refer to chapter 1 "Wiring diagram of vehicle"
3. Adjusting the free clearance of brake cable
Refer to "Adjustment of Front Brake" and
"Adjustment of free clearance about left handle
lever and rear brake pedal" in chapter 2.
4. Adjusting the toe-in of front wheel
Refer to "Adjustment of front wheel Toe-in" in
chapter 2.
99