(Iv) Selection And Installation Of Adjusting Washer - Baja WD250U Service Manual

4) Mount:
• Left crankcase cover (1)
• Fasten screw (8 pieces 7Nm)
5) Mount:
• Starting click pulley assy (1)
CAUTION:
• Fix the click pulley with rotor seat and tighten
1
the bolt
• Before mounting the starting click
pulley, apply grease on oil sealing and O-ring
(3).
(IV) Selection and installation of adjusting
washer when mounting the crankcase.
50 Nm
When mounting the crankcase, output gear and
output shaft, the applied washer thickness is
determined by the actual machining dimension of
the following parts. Adjust the correct break-in of
he level gear and the clearance of every moving
parts by washer thickness.
1
3
• Crankcase
• Output gear
• Reverse gear
• Rear cover
• Forward gear
• Output shaft
When replacing above parts, must select the ad-
justing washer again.
1. Mounting position of washer
[A] =Washer of output gear
[B] =Washer of forward gear
[C] =Washer of reverse gear
[D] =Washer of output shaft
203