Baja WD250U Service Manual page 142

(III) If the HB indicator light is out
1. Bulb and socket
•Check if the bulb and socket circuit B are
correct.
PASS
2. High or low beam switch
• Refer to "Inspection of switch"
PASS
3. Voltage
• Connect pocket tester (DC 20V) to the tail-
lamp terminal
Pocket tester (+) - brown terminal (1)
Pcoket tester (-) - yellow terminal (2)
• Adjust main switch to "ON" position
• Check voltage (12V)
Meet specification
No failure on this circuit
No electricity
Replace bulb and socket
No electricity
Replace handlerbar switch (left)
Out of specification
If there is failure on the circuit from the main
switch to the bulb socket, repair it.
141