Baja WD250U Service Manual page 119

Section 3 Check Lamp (headlight)
Check the lamp condition
1. Remove the lamp
CAUTION:
Pay attention to support the lamp. Do not pull the lead wire, otherwise it will brake.
WARNING:
When the headlight illuminates, remove your hand from the lamp, it will be very hot. Do not
touch until it has cooled down.
Color indication:
Br-brown
R-red
B-black
B/W-black/white
Bl-blue
G-green
Y-yellow
Br/W-brown/white
R/W-red/white
2. Check if the circuit of lamp terminal in on
• Adjust the choice knob of the pocket multime-
ter to "Ωx1"
• Connect the multimeter pen to correspond-
ing lamp wire end, First connect the multimeter
pen (+) to wire end (1) and pen (-) to wire end
(2) to check the circuit between (1) and (2) .
Then connect the multimeter pen (+) to wire end
1 pen (-) to wire end 3 to check the circuit be-
tween (1) and (3). If it displays "∞" one time,
replace the lamp.
3. Mount a checked lamp to check the lamp
seat. The same as checking the lamp, connect
the multimeter pen to related lamp seat wire and
check the circuit by the same method as above.
O-orange
Sb-sky blue
G/Y-green/yellow
W-white
G/Bl-green/blue
Y/R- yellow/red
Y/G-yellow/gree
B/Y-black/yellow
118