Enabling Vcare Settings In Service Mode - Konica Minolta bizhub PRESS C6000 Setup Instructions

Note: These settings might need to be set depending on the vCare system and
customer's network requirements.
9. Press OK Close
F. Enabling vCare settings in Service Mode
1. Press Utility\Counter -> Stop -> 00 -> Stop -> 01 to enter TECH REP MODE.
2. Select [System Setting].
3. Select [Software SW Switch] setting.
4. Change left Dipswitch to 03 and middle bit to 6 and press right data bit to On (1).
Note: This dipswitch must be enabled to perform CSRC memory initialization. This
dipswitch will reset back to 0 after CSRC memory initialization is performed.
5. Press Return and then Service
6. Select [State Confirmation] -> [I/O Check] -> 15 from keypad -> Press Access ->
98 from keypad -> Start. The OUT mode display should read FIN after short period
of time.
Konica Minolta bizhub PRESS C6000/C7000/C8000/C70hc Main Body bizhub vCare HTTP Setup Guide
Close Exit
Page 5 of 21