Enabling Vcare Settings In Service Mode - Konica Minolta bizhub PRO C5500 Setup Instructions

Note: These settings might need to be set depending on the Customer's network
requirements
9. Press OK Close
F. Enabling vCare settings in Service Mode
1. Press Utility\Counter -> Stop -> 00 -> Stop -> 01 to enter TECH REP MODE.
2. Select [System Setting].
3. Select [Software SW Switch] setting.
4. Change left Dipswitch to 03 and middle bit to 6 and press right data bit to On (1).
Note: This dipswitch must be enabled to perform CSRC memory initialization. This
dipswitch will reset back to 0 after CSRC memory initialization is performed.
5. Press Return and then Service
6. Select [05 State Confirmation] -> [01 I/O Check] -> 15 from keypad -> Press
Access -> 98 from keypad -> Start. The display should read FIN after short period of
time.
7. Press Return and Close
8. In TECH REP MODE, select [03 System Setting] -> [01 Software Switch].
9. Only for the bizhub Pro C5500/C6500, set dipswitch 16 bit 7 to ON(1) in order to use
the Main Body NIC for vCare.
Note: Do Not set this dipswitch for the C5501/C6501.
Konica Minolta bizhub PRO C5500/C5501, C6500/C6501 Main bizhub vCare HTTP Setup Guide
Close Exit
Page 5 of 18