Disassembling And Assembling - wsm L503 Workshop Manual

L3130 · L3430 · L3830 · L4630 · L5030, WSM

(2) Disassembling and Assembling

(A) Clutch Housing
Draining the Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from filling port after removing the filling plug (2) until
reaching the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the oil
level again, add the fluid to prescribed level if it is not correct
level.
L3130
L3430
Transmission fluid L3830
capacity L4630
L5030
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7, 8.)
• Do not mix different brands of fluid together.
(1) Drain Plugs
(2) Filling Plug
(3) Dipstick
ROPS (Center ROPS Type)
1. Remove the upper frame (1) from ROPS lower frame (2).
2. Disconect the light connectors.
3. Remove the shields (3).
4. Remove the lower frames (2).
(When reassembling)
NOTE
• Do not firmly tighten all screws until most components are
attached.
Lower frame mounting
Tightening torque
screw
(1) Upper Frame
(2) Lower Frame
3-S18
TRANSMISSION
42 L
11.1 U.S.gals
9.2 Imp.gals
43 L
11.4 U.S.gals
9.5 Imp.gals
45 L
11.9 U.S.gals
9.9 Imp.gals
(A) Oil level is acceptable within this
range.
W1012748
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 ft-lbs
(3) Shield
W1049334
KiSC issued 02, 2007 A