wsm L503 Workshop Manual page 310

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Battery, Front Grill, Skirt and Bonnet
1. Open the bonnet and disconnect the battery negative cable.
2. Disconnect the head light connector and remove the front grill (4).
3. Remove the left and right side skirts (3).
4. Disconnect window washer hoses (2).
5. Remove the bonnet (1).
NOTE
• When disconnecting the battery cords, disconnect the
negative cord first, when connecting, positive cord first.
(1) Bonnet
(2) Window Washer Hose
Steering Joint, Brake Pedal Rod and Electric Wiring
1. Remove the tank frame support (2).
2. Remove the universal joint bolt (10) and steering joint support (3),
and then remove the steering joint (1).
3. Disconnect the hand accelerator wire (7).
4. Disconnect the wiring connectors for engine stop solenoid (8),
engine tachometer sensor (9) and glow plug.
5. Disconnect the heater hoses (4), and then reconnect their hoses
to make loop.
NOTE
• Put a mark to the each heater hose before disconnecting.
6. Disconnect the wiring connector for window washer tank (5) and
compressor 1P connector (6).
7. Disconnect the brake pedal rod.
(When reassembling)
• When accelerator wire is installed, adjust the wiring length as hit
both the idling speed adjusting bolt and the maximum speed
adjusting bolt by lever within the stroke of the accelerator lever.
• Set the steering joint (1) by the joint support (3) so that the
steering wheel is turned lightly.
• Be sure to check and adjust the brake pedal free travel. (See
page G-18.)
(1) Steering Joint
(2) Tank Frame Support
(3) Steering Joint Support
(4) Heater Hose
(5) Window Washer Tank
3-S93
TRANSMISSION
(3) Skirt
(4) Front Grill
W1242861
(6) 1P Connector
(7) Accelerator Wire
(8) Engine Stop Solenoid
(9) Engine Tachometer Sensor
(10) Universal Joint Bolt
W1065071
KiSC issued 02, 2007 A