wsm L503 Workshop Manual page 518

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Transmission Model Input Mode (Mode "I")
(Input the transmission model into IntelliPanel)
NOTE
• When the IntelliPanel is replaced, this operation is required.
• On the HST models, the range gear shift lever sensor must
be adjusted at the same time.
1. Select mode "I" (See page 9-S12 "Mode Selection").
2. "MHG" is displayed (b), and the existing symbol setting is
flashing.
(Reference)
• "M" : Manual Transmission Model
"H" : HST Model
"G" : GST Model
3. To change the setting, select either "G" or "M", and input to the
IntelliPanel. Each time display mode switch is pressed, the
flashing symbol shifts. And then, hold down switch for more than
2 seconds with the symbol flashing.
4. "OK" is displayed (c) : The tractor model has been input
correctly.
If "NG" is displayed (d) : The tractor model has not been input
correctly. Repeat the procedure.
5. Turn off the main switch to end the mode "I".
(a) Mode Selection Display
(b) Input Display
Adjustment of HST range gear shift lever sensor
(for HST Model)
NOTE
• When the IntelliPanel or range gear shift sensor was
replaced, this adjustment is required.
1. Set the range gear shift lever to the M position.
2. Select mode "I" and then select "H" of the HST model according
to above procedure.
3. "OK" is displayed (c) : Lever sensor voltage is as specified.
"ERROR 71" is displayed (d) with buzzer : Lever sensor voltage
is not specified.
In this case;
- Check to see that the range gear shift lever is at M position.
- Check the lever sensor voltage in the Test Mode (Mode "A")
(see page 9-S13). If out of specification, replace the sensor.
4. Turn off the main switch to end the mode "I".
(a) Mode Selection Display
(b) Information Display
9-S19
ELECTRICAL SYSTEM
(c) Correct Preserving Display
(d) Incorrect Preserving Display
W1014885
(c) Correct Preserving Display
(d) Error Display
W1021589
KiSC issued 02, 2007 A