L3130 · L3430 · L3830 · L4630 · L5030, WSM
ECU Connector
1. Remove the seat.
2. Remove the seat bracket (1) with seat suspension (2) as a unit.
3. Disconnect the ECU connector (4).
(1) Seat Bracket
(2) Seat Suspension
Connector Voltage
(Main Circuit)
1. Turn on the main switch. (Do not start engine.)
2. Measure the voltage between terminal 31 (+) and terminal 7 (–).
3. It is OK if the voltage equals to the battery voltage.
(Sensor Voltage)
1. Turn on the main switch. (Do not start engine.)
2. Measure the voltage between terminal 34 (+) and terminal 33 (–).
3. It is OK if the voltage is approx. 5 V.
Terminal 31 to 7
Voltage
Terminal 34 to 33
A : Connector of wire harness side
GST Lever Sensor Voltage
1. Turn on the main switch. (Do not start engine.)
2. Measure the voltage between terminal 42 (+) and terminal 34 (–).
3. It is OK if the voltage comes to show in the table below.
GST lever at Neutral
Voltage between
GST lever at 8th
terminal 42 to 34
GST lever at 12th
A : Connector of wire harness side
9-S29
ELECTRICAL SYSTEM
(3) ECU (Electric Control Unit)
(4) ECU Connector
W1039817
Approx. battery voltage
Approx. 5 V
W1039947
Approx. 0.7 V
Approx. 3.07 V
Approx. 4.21 V
W1040168
KiSC issued 02, 2007 A