wsm L503 Workshop Manual page 257

L3130 · L3430 · L3830 · L4630 · L5030, WSM
PTO Shaft
1. Remove the PTO shaft cover.
2. Remove the bearing case mounting screws, and draw out the
PTO shaft (1) with bearing case (2).
3. Remove the internal snap ring (3).
4. Top out the PTO shaft (1) to the front.
(When reassembling)
• If the lock nut (6) was removed, replace it with a new one. After
replacing, be sure to stake it firmly.
• Install the slinger (7) firmly.
• Apply grease to the oil seal (4) and install it, noting its direction.
Lock nut
Tightening torque
Bearing case mounting
screw
(1) PTO Shaft
(2) Bearing Case
(3) Internal Snap Ring
(4) Oil Seal
(5) Oil Seal Collar
Differential Gear Assembly
1. Remove the differential support, noting the number of left shims.
2. Take out the differential gear assembly, noting the number of
right shims.
(When reassembling)
• Check the spiral bevel gear for wear or damage. If it is no longer
serviceable, replace it. Then, also replace the spiral bevel pinion.
• Use same number of shims as before disassembling.
Differential support
Tightening torque
mounting screw
3-S40
TRANSMISSION
147 to 196 N·m
15 to 20 kgf·m
108 to 145 ft-lbs
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(6) Lock Nut
(7) Slinger
[A] L3130, L3430
[B] L3830, L4630
[C] L5030
W10242030
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
W10245370
KiSC issued 02, 2007 A