wsm L503 Workshop Manual page 329

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Transmission Bearing Holder
1. Remove the transmission bearing holder mounting screws.
2. Tap out the spring pin (8) on the shift fork rod (3).
3. Jack up the bearing holder (1) by using the two jack screws (5)
until the taper roller bearing (7) can be removed.
NOTE
• Jack up the bearing holder while hitting the two shafts (2) (4)
by copper hummer or soft hummer.
4. Jack up more and remove the transmission bearing holder (1).
(When reassembling)
• Tap in the transmission bearing holder with soft hummer until
contact to transmission case, and then tighten the screws to
specified torque.
• Tap in the spring pin (8) so that its split portion may face forward.
(Refer to figure.)
Transmission bearing
Tightening torque
holder mounting screw
(1) Transmission Bearing Holder
(2) Spiral Bevel Pinion Shaft
(3) Shift Fork Rod for Range Gear Shift
(4) PTO Drive Shaft
(5) Jack Screw
3-S112
TRANSMISSION
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 ft-lbs
(6) Pinion Bearing Case
(7) Taper Roller Bearing
(8) Spring Pin
(9) Range Gear Shaft
(10) Front Wheel Drive Shaft
W1267434
KiSC issued 02, 2007 A