wsm L503 Workshop Manual page 169

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Hydraulic Pipes
1. Remove the main delivery pipe 1 (2).
2. Remove the PTO delivery pipe (3). (Manual and GST model)
3. Disconnect the suction hose (1) from hydraulic pump.
4. Remove the joint bolt (4) of oil cooler pipe (5). (HST model)
(When reassembling)
Joint bolt for main delivery
pipe 1 to front hydraulic
block
Joint bolt for PTO delivery
Tightening torque
pipe
Joint bolt for oil cooler pipe
(1) Suction Hose
(2) Main Delivery Pipe 1
(3) PTO Delivery Pipe
(4) Joint Bolt
Propeller Shaft
1. Slide the propeller shaft cover (4) and (8) after removing the
screws (7).
2. Tap out the spring pins (2), (6) and slide the couplings (1), (5) and
then remove the propeller shaft with covers (4), (8).
(When reassembling)
• Apply grease to the splines of propeller shaft 1 (3).
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft 1
(4) Propeller Shaft Cover
2-S13
CLUTCH
49 to 69 N·m
5.0 to 7.0 kgf·m
36.1 to 50.6 ft-lbs
34 to 39 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
34 to 39 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
(5) Oil Cooler Pipe
[A] Manual and GST Model
[B] HST Model
W1021456
(5) Coupling
(6) Spring Pin
(7) Screws
(8) Propeller Shaft Cover
W1021671
KiSC issued 02, 2007 A