wsm L503 Workshop Manual page 110

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Propeller Shaft
1. Slide the propeller shaft cover (4) and (8) after removing the
screws (7).
2. Tap out the spring pins (2), (6) and slide the couplings (1), (5) and
then remove the propeller shaft with covers (4), (8).
(When reassembling)
• Apply grease to the splines of propeller shaft 1 (3).
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft 1
(4) Propeller Shaft Cover
Separating Engine and Clutch Housing
1. Place the disassembling stand under the engine and clutch
housing case.
2. Remove the fuel tank support mounting screws.
3. Remove the engine and clutch housing mounting screws and
nuts.
4. Separate the engine and clutch housing while lifting up the tank
frame.
(When reassembling)
• Apply grease to the spline of clutch shaft.
• Apply liquid gasket (Three Bond 1211 or equivalent) to joint face
of the flywheel housing and clutch housing.
Engine and clutch housing
mounting screw and nut
Tightening torque
Engine and clutch housing
mounting stud bolt
Fuel Tank
1. Remove the muffler (5). (ROPS model)
2. Disconnect the overflow hoses (3) and fuel hose (8).
3. Remove the reserve tank bracket (6). (ROPS model)
4. Remove the compressor bracket. (Cabin model)
5. Remove the shutter plate (4).
6. Remove the tank frame mounting bolt and remove the fuel tank
(2) with frame (1).
(When reassembling)
Tightening torque Muffler mounting screw
(1) Fuel Tank Frame
(2) Fuel Tank
(3) Overflow Hoses
(4) Shutter Plate
1-S23
ENGINE
(5) Coupling
(6) Spring Pin
(7) Screws
(8) Propeller Shaft Cover
W1068780
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
39.2 to 49.0 N·m
4.0 to 5.0 kgf·m
28.9 to 36.2 ft-lbs
W1069132
31.4 to 37.2 N·m
3.2 to 3.8 kgf·m
23.1 to 27.5 ft-lbs
(5) Muffler
(6) Reserve Tank Bracket
(7) Recovery Tank
(8) Fuel Hose
W1015605
KiSC issued 02, 2007 A