wsm L503 Workshop Manual page 280

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Clutch Housing Bearing Holder
1. Remove the three interlock balls (2) after removing the stopper
screw (1).
2. Pull out the clutch housing bearing holder (4) with using two jack
bolts (3).
(When reassembling)
• Tap in the clutch housing bearing holder (4) with plastic hummer
until contact to clutch housing case, and then tighten the screws
to specified torque.
• Install the three interlock balls (2) with a small amount of grease
to the clutch housing bearing holder (4) after setting the shift forks
and shift rods to the neutral position.
Clutch housing bearing
holder mounting screw
Tightening torque
Stopper screw
(1) Stopper Screw
(2) Interlock Ball
Shaft Assemblies
1. Remove the external snap ring (1) and thrust collar (2).
2. Draw out the shaft assemblies (4), (5), (6), (7), (9) and shift forks
(10) and rods.
3. Pull out the front axle drive shaft (8) to the rear side.
(When reassembling)
• Install the front axle drive shaft (8) from front side after
assembling the clutch housing case and mid case. Then install
the bearing (13), sleeve (14), collar (15), oil seal (12), internal
snap ring (11), O-ring (16) and spacer (17) in order.
(1) External Snap Ring
(2) Collar
(3) Shuttle Shift Arm
(4) 18T Gear Shaft Assembly
(5) Idle Shaft Assembly
(6) PTO Counter Shaft Assembly
(7) Main Gear Shaft Assembly
(8) Front Axle Drive Shaft
(9) Counter Shaft Assembly
(10) Shift Fork
3-S63
TRANSMISSION
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
34.3 to 44.1 N·m
3.5 to 4.5 kgf·m
25.3 to 32.5 ft-lbs
(3) Jack Bolt
(4) Clutch Housing Bearing Holder
W1049879
(11) Internal Snap Ring
(12) Oil Seal
(13) Bearing
(14) Sleeve
(15) Collar
(16) O-ring
(17) Spacer
F : Front Side
W1050076
KiSC issued 02, 2007 A