wsm L503 Workshop Manual page 279

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Shaft Case
1. Remove the shaft case mounting screws.
2. Screw down the two M6 screws (1) into the shaft case (2) and pull
it out.
3. Take out the shaft case (2).
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the shaft case and clutch housing case.
(When replacing oil seal in shaft case)
• Install the oil seal (3) as shown in the figure, noting its direction.
• Apply grease to the oil seal (3).
(1) M6 Screw
(2) Shaft Case
23T (24T) Gear Shaft and 27T (26T) Gear
1. Remove the 23T (24T) gear shaft (1).
2. Remove the external snap ring (3) and 27T (26T) gear (2).
(When reassembling)
• Install the oil seal (4) on the 18T gear shaft (6), noting the
direction of the oil seal (4) as shown in the figure.
• Direct the boss side of the gear (2) to the bearing side.
• Apply small amount of the grease to the oil seal (4), (5).
(1) 23T Gear Shaft (L4630)
24T Gear Shaft (L5030)
(2) 27T Gear (L4630)
26T Gear (L5030)
3-S62
TRANSMISSION
(3) Oil Seal
W11776010
(3) External Snap Ring
(4) Oil Seal
(5) Oil Seal
(6) 18T Gear Shaft
W1049580
KiSC issued 02, 2007 A