wsm L503 Workshop Manual page 125

L3130 · L3430 · L3830 · L4630 · L5030, WSM
(C) Piston and Connecting Rod
Crank Gear
1. Draw out the crank gear (1) with a puller (2).
2. Remove the feather key.
(1) Crank Gear
Oil Pan and Oil Strainer
1. Remove the oil pan mounting screws.
2. Remove the oil pan (1) by lightly tapping the rim of the pan with
a wooden hammer.
3. Remove the oil pan gasket (2).
4. Remove the oil strainer (3) and O-ring (4).
(When reassembling)
• After cleaning the oil strainer (3), check to see that the filter mesh
in clean, and install it.
• Visually check the O-ring (4), apply engine oil, and install it.
• Securely fit the O-ring (4) to the oil strainer (3).
• Apply a liquid gasket (Three Bond 1215 or equivalent) to the oil
pan side of the oil pan gasket (2).
• To avoid uneven tightening, tighten oil pan mounting screws in
diagonal order from the center.
(1) Oil Pan
(2) Oil Pan Gasket
1-S38
ENGINE
(2) Gear Puller
W1025476
(3) Oil Strainer
(4) O-ring
W1025687
KiSC issued 02, 2007 A