wsm L503 Workshop Manual page 326

L3130 · L3430 · L3830 · L4630 · L5030, WSM
HST Linkages
1. Remove the cruise adjusting rod (3).
2. Disconnect the neutral rod (5) from connecting shaft (2).
3. Disconnect the damper (6) from neutral holder arm (9).
4. Remove the neutral rod (5), neutral holder (9) and neutral holder
arm (10) as a unit.
5. Disconnect the cruise spring (8), and remove the damper stay (7)
with damper (6).
6. Remove the cruise release wire (1).
(When reassembling)
• When installing the cruise wire (1) to the damper bracket (7) set
the lock nuts (4) so that the threaded position of wire (1) becomes
end.
• Be sure to check the cruise wire releasing. (See page 3-S92.)
• Be sure to adjust the HST neutral position. (See page 3-S90.)
(1) Cruise Release Wire
(2) Connecting Shaft
(3) Cruise Adjusting Rod
(4) Lock Nut
(5) Neutral Rod
Cruise Linkage, Rear Hydraulic Block and Lift Arm Bracket
1. Remove the cruise lever rod (7) and release spring (8).
2. Remove the cruise assembly mounting screws (Three screws)
and remove the cruise assembly (1).
3. Remove the range gear shift lever rod and remove the range
gear shift lever sensor (2) with stay.
4. Remove the external snap ring and remove the range gear shift
lever (5) and cruise control lever (4).
5. Remove the rear hydraulic block (3), cover and lift arm support
(6) as a unit.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the differential case and cover.
• Be sure to check cruise lever operation force and cruise control
linkage. (See page 3-S90.)
(1) Cruise Assembly
(2) Range Gear Shift Lever Sensor
(3) Rear Hydraulic Block
(4) Cruise Control Lever
3-S109
TRANSMISSION
(6)Damper
(7)Damper Stay
(8)Cruise Spring
(9)Neutral Holder
(10)Neutral Holder Arm
W1263843
(5) Range Gear Shift Lever
(6) Lift Arm Support
(7) Cruise Lever Rod
(8) Return Spring
W1264120
KiSC issued 02, 2007 A