L3130 · L3430 · L3830 · L4630 · L5030, WSM
Bevel Gear Case and Gears
1. Remove the axle case support (7). (L5030 only)
2. Remove the external snap ring (1).
3. Tap the bevel gear case (2) and separate it from the front gear
case (3).
4. Remove the internal snap ring (4).
5. Take out the bevel gears (5), (6) with ball bearings, and shims
(8).
(When reassembling)
• Install the shims (8) to their original position.
• Install the oil seal (9) of bevel gear case, noting its direction.
Axle case support
Tightening torque
mounting screw
(1) External Snap Ring
(2) Bevel Gear Case
(3) Front Gear Case
(4) Internal Snap Ring
(5) Bevel Gear
Axle
1. Remove the bearing with a special use puller set (Code No.
07916-09032).
2. Take out the bevel gear (2).
3. Take out the collar (1).
4. Tap out the axle (3).
(When reassembling)
• Install the oil seal (5) of axle flange (4), noting its direction as
shown in the figure below.
(1) Collar
(2) Bevel Gear
(3) Axle
6-S11
FRONT AXLE
127 to 142 N·m
13.0 to 14.5 kgf·m
94.0 to 104.9 ft-lbs
(6) Bevel Gear
(7) Axle Case Support
(8) Shim
(9) Oil Seal
W10160540
(4) Axle Flange
(5) Oil Seal
W10163910
KiSC issued 02, 2007 A